Pipe Fencing in Burnet, TX for Ranches and Homesteads

Ranch pipe fencing is built for the places where livestock put real pressure on a fence: working pens, sorting alleys, holding traps and the corners of the pasture closest to the barn. Pipe posts and a welded top rail give the fence a rigid frame that cattle cannot push over or bend out of shape.

Between the posts, the fill depends on the job. Pipe rails make the strongest pen for cattle. Cable or sucker rod strung between the posts keeps a clean look on longer runs. Woven or welded wire mesh attached to the pipe frame holds goats, sheep and calves that would slip through rails.

Ranch pipe fencing pairs well with wire. Many places run barbed wire or high tensile across open pasture and switch to pipe where the animals gather, so each part of the property gets the strength it needs without paying for pipe on every mile.

A welded pipe fence starts with posts set deep and plumb, because every rail and every weld depends on them. Posts are set in concrete or driven, depending on the soil and the load, and they are capped or sealed at the top so rain does not collect inside the pipe and rust it from within.

The top rail is then welded across the posts in one continuous line, which ties the whole fence together so it moves as a single frame instead of a row of separate posts. Additional rails, cable or mesh go on after that. Each joint is welded and cleaned up so the fence looks finished up close, not only from the road.

Ground conditions shape the work. Granite and limestone are part of the landscape across Burnet County, so post holes in rocky ground take more time and the right equipment. Planning the line around the worst rock, without losing the layout you want, is part of building a welded pipe fence that stays straight.